Parameters: 0-** Operation And Display - Danfoss VLT AutomationDrive FC 300 Programming Manual

Parameter Descriptions

3.2 Parameters: 0-** Operation and Display

Parameters related to the fundamental functions of the
frequency converter, function of the LCP buttons and config-
uration of the LCP display.
3.2.1 0-0* Basic Settings
0-01 Language
Option: Function:
Defines the language to be used in the
display. The frequency converter can be
delivered with 4 different language
packages. English and German are
included in all packages. English cannot
be erased or manipulated.
[0] English Part of Language packages 1 - 4
*
[1] Deutsch Part of Language packages 1 - 4
[2] Francais Part of Language package 1
[3] Dansk Part of Language package 1
[4] Spanish Part of Language package 1
[5] Italiano Part of Language package 1
Svenska Part of Language package 1
[7] Nederlands Part of Language package 1
[10] Chinese Part of Language package 2
Suomi Part of Language package 1
[22] English US Part of Language package 4
Greek Part of Language package 4
Bras.port Part of Language package 4
Slovenian Part of Language package 3
Korean Part of Language package 2
Japanese Part of Language package 2
Turkish Part of Language package 4
Trad.Chinese Part of Language package 2
Bulgarian Part of Language package 3
Srpski Part of Language package 3
Romanian Part of Language package 3
Magyar Part of Language package 3
Czech Part of Language package 3
Polski Part of Language package 4
FC 300 Programming Guide
0-01 Language
Option:
[52] Hrvatski
0-02 Motor Speed Unit
Option:
[0]
[1]
0-03 Regional Settings
Option:
[0]
[1]
This parameter cannot be adjusted while the motor is
running.
0-04 Operating State at Power-up (Hand)
Option:
[0]
®
MG.33.MB.02 - VLT is a registered Danfoss trademark
Function:
Russian Part of Language package 3
Thai Part of Language package 2
Bahasa Indonesia Part of Language package 2
Function:
This parameter cannot be adjusted while the motor is
running.
The display showing depends on settings in 0-02 Motor
Speed Unit and 0-03 Regional Settings. The default
setting of 0-02 Motor Speed Unit and 0-03 Regional
Settings depends on which region of the world the
frequency converter is supplied to, but can be re-
programmed as required.
NOTE
Changing the Motor Speed Unit will reset certain
parameters to their initial value. It is
recommended to select the motor speed unit
first, before modifying other parameters.
RPM Selects display of motor speed variables and
*
parameters (i.e. references, feedbacks and limits) in
terms of motor speed (RPM).
Hz Selects display of motor speed variables and
*
parameters (i.e. references, feedbacks and limits) in
terms of output frequency to the motor (Hz).
Function:
Interna- Activates 1-20 Motor Power [kW] for setting the
*
tional motor power in kW and sets the default value of
1-23 Motor Frequency to 50Hz.
US Activates 1-20 Motor Power [kW] for setting the
*
motor power in HP and sets the default value of
1-23 Motor Frequency to 60Hz.
Function:
Selects the operating mode upon
reconnection of the frequency converter to
mains voltage after power down in Hand
(local) operation mode.
Resume Restarts the frequency converter maintaining
the same local reference and the same start/
stop settings (applied by [HAND ON/OFF]) as
before the frequency converter was powered
down.
3 3
23