Parameter Descriptions - Danfoss VLT AutomationDrive FC 300 Programming Manual

Parameter Descriptions

3 Parameter Descriptions
3.1 Parameter Selection
3 3
Parameters for FC 300 are grouped into various parameter
groups for easy selection of the correct parameters for
optimized operation of the frequency converter.
0-** Operation and Display parameters
•
Basic Settings, set-up handling
•
Display and Local Control Panel parameters for
choosing readouts, setting up selections and
copying functions
1-** Load and Motor parameters includes all load and motor
related parameters
2-** Brake parameters
•
DC brake
•
Dynamic brake (Resistor brake)
•
Mechanical brake
•
Over Voltage Control
3-** References and ramping parameters includes DigiPot
function
4-** Limits Warnings; setting of limits and warning
parameters
5-** Digital inputs and outputs includes relay controls
6-** Analog inputs and outputs
7-** Controls; Setting parameters for speed and process
controls
8-** Communication and option parameters for setting of FC
RS485 and FC USB port parameters.
9-** Profibus parameters
10-** DeviceNet and CAN Fieldbus parameters
12-** Ethernet parameters
13-** Smart Logic Control parameters
14-** Special function parameters
15-** Drive information parameters
22
FC 300 Programming Guide
16-** Readout parameters
17-** Encoder Option parameters
18-** Readout 2 parameters
30-** Special Features
32-** MCO Basic Settings parameters
33-** MCO Adv. Settings parameters
34-** MCO Data Readouts
35-** Sensor Input Option parameters
®
MG.33.MB.02 - VLT is a registered Danfoss trademark