Parameters: 0-** Operation And Display - Danfoss VLT CDS302 Operating Instructions Manual

Parameter Descriptions

6.2 Parameters: 0-** Operation and Display

6.2.1 0-0* Basic Settings
0-01 Language
Option:
[0] English
*
[1] German
[2] French
[3] Danish
[4] Spanish
[5] Italian
6 6
0-02 Motor Speed Unit
Option: Function:
Select display of motor speed parameters (i.e.
references, feedbacks and limits) in terms of shaft
speed (RPM) or output frequency to the motor (Hz).
[0] RPM
*
[1] Hz
NOTE
This parameter cannot be adjusted while the motor is
running.
0-04 Operating State at Power-up (Hand)
Option:
[0] Resume
[1] Forced stop,
*
ref=old
[2] Forced stop,
ref=0
0-10 Active Set-up
Option:
[0] Factory setup Cannot be changed. It contains the Danfoss
[1] Set-up 1
*
46
Operating Instructions VLT
Function:
Defines the language to be used in display.
Function:
Selects the operating mode upon
reconnection of the frequency converter to
mains voltage after power down in Hand
(local) operation mode.
Restarts the frequency converter, maintaining
the same and the same start/stop settings
(applied by [Hand On/Off]) as before the
frequency converter was powered down.
Restarts the frequency converter with a
saved local reference, after mains voltage
reappears and after pressing [Hand On].
Resets the local reference to 0 upon
restarting the frequency converter.
Function:
Select the set-up to control the frequency
converter functions.
data set, and can be used as a data source
when returning the other set-ups to a
known state.
[1] Set-up 1 to [4] Set-up 4 are the four
separate parameter set-ups within which all
parameters can be programmed.
®
MG34M302 - VLT
®
CDS302 and CDS303
0-10 Active Set-up
Option:
[2] Set-up 2
[3] Set-up 3
[4] Set-up 4
[9] Multi Set-up
Use 0-51 Set-up Copy to copy a set-up to one or all other
set-ups. Stop the frequency converter before switching
between set-ups where parameters marked 'not
changeable during operation' have different values. To
avoid conflicting settings of the same parameter within
two different set-ups, link the set-ups together using
0-12 This Set-up Linked to. Parameters which are 'not
changeable during operation' are marked FALSE in the
parameter lists in 6.16 Parameter Lists.
0-11 Edit Set-up
Option:
[0] Factory setup Cannot be edited but it is useful as a data
[1] Set-up 1
*
[2] Set-up 2
[3] Set-up 3
[4] Set-up 4
[9] Active Set-up Can also be edited during operation. Edit
is a registered Danfoss trademark/Commercial Compressor
Function:
Remote selection of set-ups using digital
inputs and the serial communication port.
This set-up uses the settings from 0-12 This
Set-up Linked to. Stop the frequency
converter before making changes to open-
and closed loop functions
Function:
Select the set-up to be edited (i.e.
programmed) during operation; either the
active set-up or one of the inactive set-ups.
source to return the other set-ups to a
known state.
[1] Set-up 1 to [4] Set-up 4 can be edited
freely during operation, independently of
the active set-up.
the chosen set-up from a range of sources:
LCP, FC RS-485, FC USB or up to five fieldbus
sites.