Danfoss VLT AutomationDrive FC 300 Programming Manual page 110

Parameter Descriptions
3.10.6 8-8* FC Port Diagnostics
These parameters are used for monitoring the Bus communi-
cation via the Port.
8-80 Bus Message Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid telegrams
*
detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of telegrams with
*
faults (e.g. CRC fault), detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid telegrams
*
addressed to the slave, sent by the frequency
converter.
8-83 Slave Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of error
*
telegrams, which could not be executed by the
frequency converter.
3.10.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range: Function:
100 RPM [0 - par. 4-13 Enter the jog speed. This is a fixed
*
RPM] jog speed activated via the serial
port or fieldbus option.
8-91 Bus Jog 2 Speed
Range: Function:
200 RPM [0 - par. 4-13 Enter the jog speed. This is a fixed
*
RPM] jog speed activated via the serial
port or fieldbus option.
FC 300 Programming Guide
®
MG.33.MB.02 - VLT is a registered Danfoss trademark
3 3
109