Connecting Power To The Em200 Expansion Modules; Connecting Power To The Branch Gateway - Avaya G430 Deploying And Upgrading

Installing the Branch Gateway and EM200

Connecting power to the EM200 expansion modules

About this task
Warning:
Connect power to the EM200 expansion modules before you connect power to the G430.
Failure to do so may cause unexpected results.
For each EM200 module you connected to the G430:
Procedure
1. Connect the power cable to the power connector on the EM200 back panel.
2. Plug the power cable into a mains socket.
The EM200 is now powered.
The V5-V6 LED on the EM200 front panel lights if the EM200 is connected to the
CONNECTOR OUT 1 connector on the rear panel of the G430. This indicates that the two
media module slots are considered slot 5 and slot 6 of the G430.
The V7-V8 LED on the EM200 front panel lights if the EM200 is connected to the
CONNECTOR OUT 2 connector on the rear panel of the G430. This indicates that the two
media module slots are considered slot 7 and slot 8 of the G430.
The PWR LED on the front panel lights, indicating the EM200 is powered.
Result
Warning:
If you wish to move an EM200 in a working system consisting of a G430 and one or two
EM200s housing media modules, you must disconnect the EM200 from power before
reconnecting the expansion cable to the new location. Failure to do so may cause unexpected
results.
Related links
Ground conductor attachments

Connecting power to the Branch Gateway

About this task
After you have mounted the Branch Gateway, optionally mounted and connected EM200
device(s), installed the media modules, and attached grounding conductors, you can connect
power to the Branch Gateway.
Procedure
1. Connect the power cable to the power connector on the Branch Gateway back panel.
July 2018
on page 34
Deploying and Upgrading Avaya G430 Branch Gateway
Comments on this document? infodev@avaya.com
42