Programming And Set Up - Geely EC718 2009 Workshop Manual

Vehicle Control System

10.3 Programming and Set Up

10.3.1 Programming and Set Up
1. Programming Note
Before control module programming, make sure the following
conditions are met:
A. Vehicle System Voltage
a. Charging system should have no trouble. In the control
module programming, firstly rule out the charging
system failure.
b. Battery voltage should be greater than 12 V but less
than 16 V. If the battery voltage is too low, before the
control module programming the battery must be
charged.
c. Do not connect the vehicle battery charger to the
battery. Incorrect or the battery charger or system
voltage caused voltage fluctuations will lead to program
failure or control module damage.
d. Turn off or disable all electrical load, battery load, such
as the following components:
• Interior Lamps
• Daylight Lamps (If equipped)
•
Heating, Ventilation and Air-Conditioning (HVAC)
System
• Engine Cooling Fans, Radio, etc.
B. Ignition switch must be placed in the correct location. In the
programming process, do not change the ignition switch
position, unless the diagnostic unit has instructions.
C. Make sure that all tools connections are solid, including the
following components and circuits:
a. Scan Tool
b. Data Link Connector (DLC) Connections
c. Power Supply Circuit
D. Do not disturb programming tool harness. Unexpected
interruption of programming will lead to program failure or
control module damage.
2. Programming and Set Up After ECM
Replacement
After ECM replacement, read the ECM security procedures.
Refer to 2.5.7.10 Replaced ECM Programming.
Programming and Set Up
3. Programming and Setup After ABS Module
Replacement
This device does not require programming or setup.
4. Module Programming and Setup After TPMS
Replacement
Replace the TPMS module, or TPMS sensor. TPMS module
and sensors need to learn specific steps to refer
to6.7.6.1 Sensor Learn.
5. Instrument Cluster Programming and Set Up
After Replacement
This device does not require programming or setup.
6. Programming and Set Up After BCM
Replacement
After replacing BCM, the remote key must be reset, detailed
steps are as follows:
Lift anti-theft case, open the driver door. Turn the key from OFF
to ON 6 times in 10 s. the last stop is at the OFF position. At
this time, the anti-theft indicator light enters the learn mode.
Hold down any key on the remote control device. If the anti-
theft light flashes once, it indicates a successful learn. Four
keys can be learned in a row. 10 s after the completion of four
keys, or after learning one key and the ignition is at "ON". End
for each learn, the previous key id will be replaced.
7. Anti-theft Control Module Programming and
Setup After Replacement
After replacing engine anti-theft control module, read security
program into the module. Refer to
Module and ECM Programming.
8. Ignition Key Programming and Setup After
Replacement
Engine anti-theft system can learn up to five keys. For detailed
steps. Refer to 2.5.7.7 Replaced Key Programming
9. Remote Key Programming and Setup After
Replacement
Refer to10.3.1 .
10. Roof Module Motor Programming and
Setup After Replacement
After replacing the roof motor module, initialize the sunroof
module motor. For detailed steps. Refer to
Initialization.
EC718/EC718RV EC715/EC715RV 10/2009
10-23
2.5.7.11 Replaced Anti-theft
11.8.7.3 Sunroof