Table of Contents
Advertisement
B.4 PROM Programming Tools
B.4.1 Hardware
PG-1500
PROM programmer
PA-78P0208GF
PROM programmer adapter
B.4.2 Software
PG-1500 controller
Remark ×××× in the part number differs depending on the host machine and OS used.
µ S××××PG1500
APPENDIX B DEVELOPMENT TOOLS
This PROM programmer allows users to encode the PROM in single-chip microcontrollers
stand-alone or using a host machine. This requires connection of the accompanying board
and separately-sold PROM programmer adapter to the PROM programmer.
Besides internal PROMs, general discrete PROM devices whose capacities range from 256
Kb to 4 Mb can be programmed.
This PROM programmer adapter is for the µ PD78P0208 and should be connected to the
PG-1500.
This adapter is for a 100-pin plastic QFP (GF-3BA type).
This software allows users to control the PG-1500 from a host machine which is connected
to the PG-1500 via serial/parallel interface cable(s).
Part Number: µ S××××PG1500
××××
Host Machine
5A13
PC-9800 series
5A10
7B13
IBM PC/AT and compatibles
7B10
Notes 1. Although a task swap function is incorporated in MS-DOS Ver. 5.0 or
later, this function cannot be used with the above software.
2. The following OSs for IBM PCs are supported (Ver. 5.0 or later of MS-
DOS has a task swap function, but this function cannot be used with the
above software).
OS
PC DOS
MS-DOS
TM
IBM DOS
User's Manual U11302EJ4V0UM
OS
MS-DOS
(Ver. 3.30 to Ver. 6.2
Note 2
Version
Ver.5.02 to Ver.6.3
J6.1/V to J6.3/V (Only the English version is supported.)
Ver.5.0 to Ver.6.22
5.0/V to 6.2/V (Only the English version is supported.)
J5.02/V (Only the English version is supported.)
Supply Medium
3.5-inch 2HD
Note 1
) 5-inch 2HD
3.5-inch 2HD
5-inch 2HC
403
Advertisement
Table of Contents
