Piston Cooling Nozzle Installation (If Removed); Oil Plug Installation (If Removed) - Lycoming TEO-540-C1A Maintenance Manual

17. Piston Cooling Nozzle Installation (if removed)

A. Apply a coating of engine oil to all of the cleaned
and inspected/acceptable piston cooling nozzles.
B. Install three piston cooling nozzles in each
crankcase half (Figure 68).
C. Torque each piston cooling nozzle to 100 in.-lb.
(11 Nm).

18. Oil Plug Installation (if removed)

Make sure the NPT oil plugs are acceptable, not damaged or cracked. Replace any worn,
A.
damaged or cracked oil plug.
Apply of coating of Loctite
B.
Install the NPT oil plugs in each crankcase half (Figures 15, 16, 17, and 69 A, B, and C).
C.
Torque each NPT oil plug in accordance with the latest revision of the Service Table of
D.
Limits - SSP-1776.
Figure A
72-20
Page 174
®
564 or equivalent to all of the oil plugs.
Figure B
Figures 69 A, B and C
Oil Plug Installation
© 2018 Avco Corporation. All Rights Reserved
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Figure 68
Piston Cooling Nozzles
Figure C
November 2018