Lycoming TEO-540-C1A Maintenance Manual page 313

TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Sensor Name Abbr.
Camshaft CAM
Speed Sensor
Oil OIL-T
Temperature
Sensor
Manifold MAP
Pressure
Sensor
© 2018 Avco Corporation. All Rights Reserved
November 2018
Table 3 (Cont.)
Sensor Replacement Procedures
ID Qty.
A004 1 Mounted on the
accessory housing
(Figure 35)
A026 1 (Figure 35)
A040 1 Mounted on the
crankcase
(Figure 35)
Location
Same as crankshaft speed sensor.
1. Disconnect the harness connector
from the sensor per instruction in
the "Wiring Harness Connectors"
section in this chapter.
2. Remove the sensor.
3. Install the new sensor. Torque
hardware to 84 to 120 in.-lb. (9.5
to 13 Nm).
4. Connect the harness connector to
the sensor per instruction in the
"Wiring Harness Connectors"
section in this chapter.
5. Complete an operational ground
check.*
1. Disconnect the wiring harness
from the sensor per instruction in
the "Wiring Harness Connectors"
section in this chapter.
2. Remove the sensor from the
engine.
3. Install the new sensor.
4. Refer to Standard Torque Tables
in the latest revision of the
Service Table of Limits - SSP-
1776 for torque values.
5. Connect the wiring harness to the
sensor per instruction in the
"Wiring Harness Connectors"
section in this chapter.
6. Complete an operational ground
check.*
Replacement Instructions
Page 283
72-70