Lycoming TEO-540-C1A Maintenance Manual page 41

TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Visual Inspection Checklist for TEO-540-C1A Engines (Cont.)
Item
Lubrication System
Examine the oil pressure relief valve,
oil cooler bypass valve, oil filter and
oil sump drain plugs to verify they
are in satisfactory condition. Ensure
that all components are secure on
their respective mountings, all
associated hose connections are
secure and that there is no evidence
of leakage.
Make sure the safety wire or safety
cable is secure and correctly installed
on the oil cooler bypass valve, oil
filter and oil sump drain plug(s).
Examine all oil hoses for leaks, wear,
and secure attachment. Make sure
that all hoses and associated cushion
clamps are secure and cannot move
or vibrate excessively. Ensure that
there are no sharp bends in the oil
hose routing and that no hoses are
near heat sources that could damage
them.
Fuel System
Examine all fuel hoses for leaks,
wear, and secure attachment. Make
sure that all fuel hoses have
cushioned clamps securely attached
to hold the fuel hoses securely in
place to prevent excessive vibration.
Make sure that there are no sharp
bends in the fuel hose routing and
that the fuel hoses are not near heat
sources that could damage the fuel
hose.
© 2018 Avco Corporation. All Rights Reserved
November 2018
Comments
Refer to Chapters 12-10
and 72-50.
Identify and correct the
cause of any leak.
Refer to Chapters 12-10
and 72-50.
Identify and correct the
cause of any leak.
Refer to the "Oil Hose
Inspection" procedure in
Chapter 72-50.
Correct any problem
before flight to make
sure the engine operates
correctly to
specifications in the
TEO-540-C1A Engine
Installation and
Operation Manual.
Identify and correct the
cause of any leak.
Refer to the "Fuel Hose
Inspection" procedure in
Chapter 73-10.
Findings/
Corrective Action
Done
05-20
Page 11