Lycoming TEO-540-C1A Maintenance Manual page 346

Inspection Item
Make sure each fuel hose is held in
place securely using serviceable
cushioned clamps to prevent fuel hose
movement due to vibration. If a fuel
hose had been in service and clamps
were not installed, replace the fuel
hose with a new fuel hose.
Make sure clamps are securely attached.
If the clamps are loose, replace the fuel
hose. Install new clamps that attach the
hose securely.
Examine the cushion on clamps for
deterioration. If cushions are
deteriorated or missing, replace the fuel
hose and the clamp with a new clamp
with the cushion intact.
Examine solder joints, as necessary, at
the end of each fuel hose for cracks.
Replace the fuel hose if a crack is found
at a solder joint.
Operate the engine and look for fuel
leaks. Identify and correct the cause of
any fuel leak or malfunction. Operate
the engine again to make sure it is
operating correctly and there is no leak
anywhere.
Tighten any loose fasteners, fittings, or
connections.*
* Per the Standard Torque Tables in the latest revision of the Service Table of Limits - SSP-1776.
73-10
Page 316
Fuel System Inspection Checklist (Cont.)
Fuel Hose
A
B
C
D
E
A
B
C
D
E
N/A
N/A
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Findings
© 2018 Avco Corporation. All Rights Reserved
Corrective Action
Taken
November 2018