Lycoming TEO-540-C1A Maintenance Manual page 155

TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Engine Assembly Checklist for TEO-540-C1A Engines (Cont.)
Complete the "Oil Pump Installation" procedure in
Chapter 72-25.
Complete the "Accessory Housing Installation"
procedure in Chapter 72-25.
Complete the "Oil Filter Base Installation"
procedure in Chapter 72-50.
Complete the "Oil Cooler Bypass Valve
Installation" procedure in Chapter 72-50.
Complete the "Fuel Pump Installation" procedure in
Chapter 73-10.
Complete the "Vacuum Pump Driven Gear
Installation" procedure in the "Vacuum Pump
Driven Gear Replacement (if installed)" section in
Chapter 72-60.
Complete the "Oil Sump Installation" procedure in
Chapter 72-50. Be sure to install a new oil sump
gasket.
Complete the "Piston Installation" procedure in
Chapter 72-30 for all six pistons. Make sure new
piston rings and new piston pin plugs are installed
on each piston.
Complete the "Cylinder Installation" procedure in
Chapter 72-30.
(If necessary) complete the "Starter Ring Gear
Replacement" procedure in Chapter 72-70.
Install the starter ring gear support per the "Starter
Ring Gear Support Installation" procedure in
accordance with the "Starter Ring Gear Support
Replacement" section in Chapter 72-70.
Complete the "Oil Filler Extension and Oil Filler
Extension and Oil Level Gage Assembly
Installation" procedure in Chapter 72-50.
Complete the "Intercylinder Baffle Installation"
procedure in the "Cylinder Installation" section in
Chapter 72-30.
Install a new oil drain tube at each cylinder head
and at the crankcase per the "Oil Drain Tube
Installation" procedure in Chapter 72-30.
Complete the "Intake Pipe Installation" procedure
in accordance with the "Intake Pipe Replacement"
section in Chapter 72-80.
Examine, set the gap, rotate, and install the spark
plugs per procedures in Chapter 74-20.
© 2018 Avco Corporation. All Rights Reserved
November 2018
Item Comments Done
72-10
Page 125