Lycoming TEO-540-C1A Maintenance Manual page 415

TEO-540-C1A Engine Maintenance Manual
Displaying ECU Active Data
The "ECU Active Data" screen
contains two panels.
• The "Active Data" panel
displays current active data.
• The "Active Faults" panel
displays active faults as they are
broadcast from the ECU.
1. Open the FST program per the
"Start the FST Program"
procedure.
2. Click on the ECU Active Data
tab (Figure C-25).
3. Click the Start button on the
"ECU Active Data" screen
(Figure C-25) to display active
faults data from the ECU.
NOTICE: If the "Active Faults"
panel is blank there is no
active fault data in the
ECU.
4. Click the Stop button (Figure
C-26) to stop reading active
data from the ECU.
NOTICE: Must be streaming
active data to record.
5. Click the Start Recording
button (Figure C-26) to record
the broadcast active data in a
file on the laptop.
NOTICE: After clicking on the
Start Recording button
it will change to a Stop
Recording button.
Click on the Stop
Recording button to
quit recording the
broadcast active data in
a file on the laptop.
© 2018 Avco Corporation. All Rights Reserved
November 2018
Figure C-25
ECU Broadcast Faults Tab
Figure C-26
Start and Stop Recording Buttons
Appendix C
Page 385