Lycoming TEO-540-C1A Maintenance Manual page 154

Engine Assembly Checklist for TEO-540-C1A Engines (Cont.)
Measure the camshaft end play in the left crankcase
half per the "Camshaft Installation" procedure in
the "Camshaft Assembly and Installation" section
of Chapter 72-20.
Install the camshaft in the right crankcase half per
the "Camshaft Installation" procedure in the
"Camshaft Assembly and Installation" section of
Chapter 72-20.
Measure the camshaft end play in the right
crankcase half per the "Camshaft Installation"
procedure in the "Camshaft Assembly and
Installation" section of Chapter 72-20.
Measure the crankshaft bearing journals. Refer to
the "Crankshaft Bearing Surface Inspection"
section in Chapter 72-20.
Complete the "Crankshaft Installation" procedure
in Chapter 72-20.
Measure the thrust face clearances between the
crankshaft and crankcase per the "Crankshaft
Installation" procedure in Chapter 72-20.
Measure the slinger clearance per the "Crankshaft
Installation" procedure in Chapter 72-20.
Measure the crankshaft end play clearance per the
"Crankshaft Installation" procedure in Chapter 72-
20.
Assemble the crankcase halves per the "Crankcase
Assembly" procedure and follow the torque
sequence in Chapter 72-20.
Complete the "Crankshaft End Play Clearance
Check" in Chapter 72-20 (after the crankcase is
assembled).
Complete the "Propeller Oil Control Leak Test" in
Chapter 72-20
Install the propeller governor per the airframe
manufacturer's instructions
Complete the "Crankshaft Oil Seal Installation"
procedure in Chapter 72-20.
Complete the "Crankshaft Trigger Gear Assembly
and Crankshaft Idler Gear Installation" procedure in
Chapter 72-20.
* Measurements must be within tolerances specified in the latest revision of the Service Table of
Limits - SSP-1776.
72-10
Page 124
Item
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Comments
*Measurement:
*Measurement:
*Measurement:
*Measurement:
*Measurement:
*Measurement:
© 2018 Avco Corporation. All Rights Reserved
Done
November 2018