Lycoming TEO-540-C1A Maintenance Manual page 57

TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
100-Hour or Annual Engine Inspection Checklist for TEO-540-C1A Engines (Cont.)
Inspection Item
Engine Controls
Examine the knock, temperature,
and pressure sensors for security
and damage.
Look at ECU Fault Codes and
investigate Fault Code cause.
Crankcase
Complete the crankcase
inspection.
Engine Accessories
Complete the accessory drive
inspection.
Engine Mounts
Complete the engine mount
inspection.
Cylinders
Complete the "Visual Cylinder Inspection" procedure in Chapter 72-30. Record the results for
each cylinder.
Inspection
Item
Cylinder 1
Cylinder 2
Cylinder 3
Cylinder 4
Cylinder 5
Cylinder 6
© 2018 Avco Corporation. All Rights Reserved
November 2018
Comments
If a damaged sensor is found,
replace the sensor. Refer to the
section "Sensor Replacement
Procedures" in Chapter 72-70.
Refer to the Troubleshooting
Guide in Appendix D of this
manual to identify the fault and
complete the Troubleshooting
Steps.
Refer to the "Exterior
Crankcase Inspection"
procedure in Chapter 72-20.
Refer to the "Accessory Drive
Inspection" procedure in
Chapter 72-60.
Refer to the "Engine Mount
Inspection" procedure in
Chapter 72-00.
Results/Notes
Results/Notes Done
Done
05-20
Page 27