Lycoming TEO-540-C1A Maintenance Manual page 296

K. Install the six bolts, six new lock washers, 12 washers, and six nuts on the accessory housing
end of the oil sump.
L. Torque all of the nuts and bolts to 96 in.-lb. (11 Nm).
M. Apply one to two drops of Loctite
install the two oil sump drain plugs in the oil sump. Torque the drain plugs in accordance
with the Standard Torque Tables in the latest revision of the Service Table of Limits - SSP-
1776.
CAUTION
N. Safety cable/wire the oil sump drain plug (and oil suction screen if not already done) in
accordance with the standard practices per the latest revision of AC43.13-1B or the latest
revision of Service Instruction No. SI-1566.
O. Install the induction housing intake pipes on the engine per respective installation instructions
in Chapter 72-80.
P. Install the throttle body assembly per instructions in Chapter 73-20.
Q. After maintenance is completed, complete the "Add Oil to the Engine" procedure.
R. Complete the "Operational Ground Check" per Chapter 72-00.
72-50
Page 266
®
564
MAKE SURE THAT THE OIL SUMP DRAIN PLUGS ARE INSTALLED
TIGHTLY. IF THE DRAIN PLUGS ARE NOT TIGHTLY INSTALLED
AND LEAK, ENGINE FAILURE CAN OCCUR.
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
™
to the threads of each oil sump drain plug and
© 2018 Avco Corporation. All Rights Reserved
November 2018