Lycoming TEO-540-C1A Maintenance Manual page 310

Wiring Harness
Connection
The wiring harness is connected to each fuel injector on all six cylinders. The wiring
Fuel Injector
harness connector for the Fuel Injector connects directly to the Fuel Injector.
Disconnect:
1. Move the green locking slide feature (Figure 27) to the unlocked position
2. Press the grey release tab (Figure 27) and pull the wiring harness connector up
Connect:
1. Install the wiring harness connector onto the sensor and press firmly until you
2. Move the green locking slide feature (Figure 27) down until you hear it click
Prop Governor
(if an electronic
prop governor is
The wiring harness connector for the Prop Governor connects directly to the Prop
installed)
Governor, located on the front left-hand side of the engine.
Disconnect:
1. Pull or pry up on the front of both locking tabs on the wiring harness connector
Connect:
1. Insert the wiring harness connector into the prop governor connection and press
72-70
Page 280
Table 2 (Cont.)
Wiring Harness Connector Guidelines
Guidelines for Disconnecting and Connecting
Figure 27
Fuel Injector Locking Slide Feature in
Connector the Unlocked Position
(Figure 28).
to remove it from the fuel injector (Figure 29).
hear the locking tab click in place.
into place.
Figure 30
Prop Governor Connector
(Figure 30) to release them from the locking features on the prop governor and
pull the wiring harness connector from the prop governor (Figure 31).
firmly until you hear the locking tabs click in place.
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Figure 28
Removed from the Fuel Injector
Wiring Harness Connector
Removed from the Prop Governor
© 2018 Avco Corporation. All Rights Reserved
Figure 29
Wiring Harness Connector
Figure 31
November 2018