Table of Contents
Advertisement
TEO-540-A1A Engine Installation and Operation Manual
3. In accordance with FAA guidelines on HIRF and Lightning, install three low impedance
grounding jumpers of 0.025 in
the engine mounting frame. The grounding jumpers must be less than 12 in. (30 cm) long.
4. Connect low impendence grounding jumpers between the engine mount and airframe, if
necessary, to ensure a conductive path from engine to airframe equivalent to the three low
impedance grounding jumpers specified in the previous step.
Step 12. Install Components That Had Been Removed Before Engine Installation and Any
Additional Ship Loose Components
1. Install any component that was removed to enable engine installation.
2. Install any remaining components that were shipped loose with the engine.
Step 13. Make Remaining Engine Connections
1. Connect EECS wiring harness to airframe adapter interface wiring harness.
2. Make engine connections to accessories.
3. Make engine connections to wires and cables.
4. Make engine connections to ducts and cowling.
5. Make engine connections to breather, hoses and pipes.
6. Connect alternator blast tubes to a source of cooling air sufficient to prevent the alternator
temperature from increasing above maximum limits set by the alternator manufacturer.
Step 14. Install Baffling
Install baffling around the engine compartment.
Step 15 Add Oil
CAUTION
OIL IN THE CORRECT QUANTITY AND OF THE CORRECT VISCOSITY
FOR THE CORRESPONDING AMBIENT TEMPERATURE MUST BE
ADDED TO THE ENGINE FOR CORRECT LUBRICATION ESSENTIAL TO
ENGINE OPERATION. REFER TO APPENDIX A FOR OIL TYPES AND OIL
SUMP CAPACITY TO HAVE THE CORRECT QUANTITY AND TYPE OF
OIL TO ADD TO THE ENGINE.
Add ashless dispersant oil to turbocharged engines, as specified in Appendix A. Refer to Chapter 12-
10 in the TEO-540-A1A Engine Maintenance Manual for the procedure to add oil.
NOTICE: To accurately calculate oil consumption, every time oil is added, record the quantity of
oil added in the engine logbook.
© 2018 Avco Corporation. All Rights Reserved
October 2018
2
2
(16 mm
) minimum conductive areas from the engine case to
Engine Installation
Page 39
Advertisement
Table of Contents
