Table of Contents
Advertisement
E. Install the two top compression rings (Figure 35) with the word "Top" toward the top of the
piston in the remaining top grooves. Orient the gaps in the two compression rings 180° from
each other parallel with the piston pin hole.
F. Compress each of the two top compression piston rings several times with your fingers to
make sure the rings are situated freely and loosely in the groove.
G. To ensure correct installation, measure the side clearance of the rings in the grooves with a
feeler gage and a straight edge (Figure 23). If the actual measurement is greater than the
maximum allowable side clearance, per the latest revision of the Service Table of Limits -
SSP-1776, replace the piston.
NOTICE: Engine break-in must be completed to seat newly installed piston rings. Refer to the
latest revision of Service Instruction No. SI-1427 and the "Engine Initiation" chapter
of the YO-233-B2A Engine Installation and Operation Manual.
17. Piston Installation
NOTICE: If more than one piston is being installed, make sure you are installing the correct piston
on the designated connecting rod in the engine.
A. Clean the pistons as per instructions in the "Piston Cleaning" procedure in Chapter 5-30.
NOTICE: If the original piston pin is tighter than a palm push fit, look for burrs or slight
carbon in the pin bore of the piston. Remove any burrs with a stone. Remove carbon
deposits as per instructions in Chapter 05-30. If a new piston or piston pin is
installed, use a pin that will give a palm push fit at 60º to 70ºF (15º to 20ºC).
B. Apply lubricant specified in the latest revision of Service Instruction No. SI-1059 to the
inside diameter of the connecting rod bushing, the outer diameter of the piston pin, and the
inside diameter of the piston pin hole.
CAUTION DO NOT ATTEMPT TO TURN THE CRANKSHAFT UNLESS THE
C. Turn the crankshaft so that when the Number 1 piston is inserted, it will be at TDC of its
firing stroke, with both tappets on the base circle of the camshaft lobes.
D. Remove the Torque Hold-Down Plates (ST-222) from the crankcase.
E. Install the piston on the connecting rod where the number stamped on the bottom of the
piston head is upright and readable (not upside-down.)
F. Insert the piston pin into the piston and through the connecting rod (Figure 18) to ensure the
entire length of the piston pin is lubricated, move the piston pin back and forth until it is
centered.
G. Insert a piston pin plug at each end of the piston pin.
H. Complete a check of the clearance between the piston and each piston pin plug. Refer to the
latest revision of the Service Table of Limits - SSP-1776 for acceptable clearance limits.
I. Install the piston rings on the piston per the "Piston Ring Replacement" procedure.
J. Apply a generous coating of a mixture of 15% pre-lubricant (STP or equivalent) and 85%
SAE 50 mineral-base aviation-grade lubricating oil (unless otherwise directed per the latest
revision of Service Instruction No. SI-1059) to the piston rings, working the mixture into the
ring grooves.
K. Apply lubricant specified in the latest revision of Service Instruction No. SI-1059 to the
piston pin plug faces.
72-30
Page 132
CONNECTING RODS ARE SUPPORTED.
YO-233-B2A Engine Maintenance Manual
TEO-540-A1A Engine Maintenance Manual
© 2021 Avco Corporation. All Rights Reserved
February 2021
Advertisement
Table of Contents
