Air Bleed Nozzle Installation - Lycoming TEO-540-C1A Maintenance Manual

Air Bleed Nozzle Installation

Install the air bleed nozzles in the upper side of the cylinder head so that the identification mark
(a letter or figure location on the 0.500 inch hex) is installed toward the bottom of the engine
within approximately one hex flat of 60 in.-lbs. (6.7 Nm).
Fin Stabilizer Installation
NOTICE: Two different widths of fin stabilizers, 0.63 in. (16.00 mm) and 0.31 in. (7.87 mm) are
to be installed on each engine cylinder in the locations shown in Figure A-3.
1. Clean the fin stabilizers and cylinder fin areas with mineral spirits or equivalent to remove all
grease, dirt, and other unwanted materials.
2. Use compressed air to dry the stabilizers and fins.
3. Apply Dow Corning
4. Install the fin stabilizers in the locations shown in Figure A-5.
Figure A-3
Fin Stabilizer Locations
Appendix A
Page 352
® ®
Silastic 140 adhesive to the cylinder fins (Figure A-4).
TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Figure A-4
Apply Adhesive
Figure A-5
Fin Stabilizer Installed on Cylinder
© 2018 Avco Corporation. All Rights Reserved
November 2018