Lycoming TEO-540-C1A Maintenance Manual page 25

TEO-540-C1A Engine Maintenance Manual
TEO-540-C1A Engine Maintenance Manual
Scope of this Manual
This manual supplies instructions (in compliance with Federal Aviation Regulation Part 14 CFR
33.4) for maintenance of the Lycoming TEO-540-C1A engine. These instructions include: required
maintenance (service information) such as: oil changes, oil addition, oil filter replacement, routine
time-interval inspections, routine service, spark plug replacement/inspection procedures, cylinder
inspection, fuel system inspection, scheduled servicing procedures, airworthiness limitations, fault
isolation guidelines and procedures for component replacement, engine disassembly, and engine
assembly. Refer to the TEO-540-C1A Illustrated Parts Catalog to identify spare parts.
Instructions for Continued Airworthiness
This manual, the TEO-540-C1A Engine Overhaul Manual, the latest revision of the Service Table
of Limits - SSP-1776, and service documents applicable to this engine model make up the complete
set of Instructions for Continued Airworthiness (ICAs). The ICAs are prepared by Lycoming
Engines.
Engine Certification
This manual adheres to guidelines set forth by the FAA for certified engines. All inspections,
procedures, and guidelines in this manual must be followed to maintain continued airworthiness.
Compliance Requirements
WARNING FOR CORRECT ENGINE MAINTENANCE, COMPLETE THE NECESSARY
MAINTENANCE PROCEDURES IN THIS MANUAL AND APPLICABLE
SERVICE DOCUMENTS. LYCOMING ENGINES' SERVICE DOCUMENTS
WRITTEN AT A LATER DATE SUPERSEDE PROCEDURES IN THIS
MANUAL UNLESS OTHERWISE SPECIFIED.
PROCEDURES IN THIS MANUAL MUST BE DONE BY QUALIFIED
PERSONNEL WITH THE REQUISITE CERTIFICATIONS.
Before you do maintenance on the TEO-540-C1A engine, read this manual in its entirety. Obey all
procedures and inspections in this manual.
NOTICE: Please read your warranty for a full statement of your rights, limitations and obligations
that exist there under.
Refer to the TEO-540-C1A Engine Installation and Operation Manual for engine description,
uncrating procedures, acceptance check, engine lift procedure, engine preservation and storage,
depreservation, engine installation requirements, engine installation, engine start, operation, and stop
procedures, engine initiation (break-in/flight test), fuels and oil to be used, and operating
specifications.
Refer to the latest revision of the Service Table of Limits - SSP-1776, for dimensions, clearances,
measurements, and torque values.
WARNING OPERATE THIS ENGINE IN ACCORDANCE WITH SPECIFICATIONS IN
APPENDIX A OF THE TEO-540-C1A ENGINE INSTALLATION AND
OPERATION MANUAL. OPERATION OF THE ENGINE OUTSIDE OF THE
SPECIFIED OPERATING LIMITS CAN CAUSE PERSONAL INJURY
AND/OR DAMAGE TO THE ENGINE.
© 2018 Avco Corporation. All Rights Reserved
November 2018
Introduction
Page xxiii