Table of Contents
Advertisement
ITEM
CONTROL NAME
NO.
1
Front Wiper/Washer
Fluid Knob
2
Rear Wiper/Washer
Fluid Knob
3
Headlight and Parking
Lights Switch
4
Front Work Lights
Switch
5
Rear Work Lights
Switch
6
Beacon Light Switch
7
All Wheel Drive
8
WORK/AUTO Switch
9
Ignition Key Switch
10
Engine Warning Light
LeeBoy Model 695 Motor Grader
Table 3-4. Side Control Panel
Used to control operation of front windshield wipers. Turn knob clockwise to
first position for low wiper speed. Continue to turn knob clockwise to second
position for high wiper speed. Push knob in for wiper washer fluid. Turn knob
counterclockwise to turn off.
Used to control operation of rear windshield wipers. Turn knob clockwise to
first position for low wiper speed. Continue to turn knob clockwise to second
position for high wiper speed. Push knob in for wiper washer fluid. Turn knob
counterclockwise to turn off.
Used to control operation of head lights. These lights illuminate the road or area
in front of motor grader during operation or transport. Push switch to middle
position for parking lights. Push switch all the way up for headlights. Push bottom
of switch all the way down to turn lights off.
Used to control operation of front work lights mounted on canopy or optional cab.
These lights illuminate work area when working at night. Push top of switch to
turn on work lights. Push bottom of switch to turn work lights off.
Controls operation of rear work lights mounted on rear of vehicle. These lights
illuminate work area when working at night. Push top of switch to turn on work
lights. Push bottom of switch to turn off work lights.
Controls operation of flashing safety light on top of canopy or optional cab.
This light warns traffic of slow moving equipment. Push top of switch to turn on
beacon(s). Push bottom of switch to turn off beacon(s).
Activates all wheel drive feature. Push the top of switch to activate all wheel drive.
Push bottom of switch to deactivate all wheel drive. ALL WHEEL DRIVE MODELS
ONLY.
Controls displacement...... Push switch up for WORK mode. Push switch down for
AUTO mode.
Controls start, run, and shut down modes of grader.
ON POSITION ---
To start grader, insert key and turn key clockwise to START (
Cold Weather Start-up: Turn key clockwise to the RUN position. Wait-to-start
indicator light will light up. When wait-to-start indicator light (Figure
3-3,3) turns off, turn key clockwise to START (
To shut down grader, turn key counterclockwise to the STOP (
remove key.
Indicates engine fault when illuminated.
Do not operate motor grader if engine warning light is
illuminated. Refer to an authorized LeeBoy Dealer and engine
operator's manual.
Component Location
FUNCTION
) position:
3 3
) position.
) position and
STOP
3-11
Advertisement
Table of Contents
