Table of Contents
Advertisement
SAFETY LABELS
If the LeeBoy grader has been repainted,
it is extremely important that all decals referring to
CAUTION, WARNING, and DANGER be replaced in their
proper locations. The illustrations on this page serve as
an aid to determine the proper locations. If needed, refer
to the parts listing in the parts section of this manual and
note the description column.
Decal information is provided below. For additional
instructions, contact your LeeBoy dealer.
NOTE: It is the responsibility of the owner and
operator to make sure that all safety labels
are readable and located on the motor
grader as designated by LeeBoy.
Safety Decals Care
• Keep safety decals and signs clean and legible at all
times.
• Become familiar with the content and the position of
each safety decal. Decals include important
information.
• Replace decals and signs that are missing or have
become impossible to read.
• When replacing parts that display a safety decal,
ensure that the new part is fitted with a decal as well.
• Obtain replacement safety decals or signs from your
authorized LeeBoy dealer.
Decal Installation (sticker type)
1.
Be sure that installation area is clean and dry. Use
hot, soapy water to clean the surface on which the
decal will be applied.
2. Thoroughly dry the surface.
3. Decide on the exact position by taking
measurements and test fitting before removing
decal paper backing.
4. For decals with no top protection paper, decide on
location for decal and remove the smallest split
backing paper.
5. Align decal over the specified area and carefully
press exposed portion into place.
6. Slowly remove remaining backing and carefully
smooth remaining portion of decal into place.
7.
Small air pockets can be pierced with a pin and
smoothed out using a piece of the decal backing.
LeeBoy Model 695 Motor Grader
Decal Installation (top protected)
1.
If the decal has a protective top paper, use hot
soapy water on the surface on which the decal will
be applied. Leave wet.
2. After deciding on decal location, remove protective
back paper and soak decal in clean soapy water
before application. Soaking will help alleviate air
bubbles in the applied decal.
3. Smooth decal into place with a squeegee and check
for air bubbles.
4. Small air pockets can be pierced with a pin and
smoothed out using a piece of the decal backing.
5. When decal is completely smoothed out, carefully
remove top paper.
Safety
1 1
1-9
Advertisement
Table of Contents
