Table of Contents
Advertisement
Figure 5-4. Loosen Tie Rod Jam Nuts
•
Use a jack to raise front wheels slightly.
•
Loosen the tie rod jam nuts (1).
•
Turn the tie rod (2) center tube to adjust toe-in
to 1/8 inch (3.2 mm).
•
Tighten jam nuts.
•
Lower grader so that wheels rest on ground.
15. Turn wheels completely left and right and check
for binding or obstruction. Repair or adjust as
necessary.
Checking Neutral Start System
1.
Refer to Preparing Grader for Maintenance on
page 5-6 and park grader.
2. Pull parking brake knob up (Figure 3-8) to engage
brake.
3. Place forward/neutral/reverse (FNR) lever (Figure
3-7) in FORWARD position.
4. Turn ignition switch key (Figure 3-3) clockwise to
the START position. Starter must not crank engine.
If starter cranks engine, release key and DO NOT
operate grader.
5. Repeat test with forward/neutral/reverse (FNR) lever
(Figure 3-7) in REVERSE position.
Do not operate grader if starter
cranks engine with forward/neutral/reverse
(FNR) lever in any gear except neutral.
See local dealer for neutral start system
troubleshooting and repair.
LeeBoy Model 695 Motor Grader
TIE ROD ASSEMBLY
2
1
6. Place forward/neutral/reverse (FNR) lever (Figure
3-7) in NEUTRAL.
7.
Turn ignition switch key (Figure 3-3) clockwise to
START position. Starter should crank engine.
BATTERY MAINTENANCE
Batteries contain sulfuric acid and
produce explosive gases that can cause
serious injury. Therefore, do not allow
flames or sparks to come near the battery.
Always wear proper protective
equipment when charging or working near
a battery.In case of acid contact with skin
or eyes, flush immediately with water for
a minimum of 15 minutes and get prompt
medical attention.
If acid is swallowed, get medical
attention immediately.
When servicing batteries, always
disconnect the negative (-) (ground) cable
first and reconnect it last. Generally, if the
negative cable is grounded during removal,
sparks will not occur. If the positive cable is
grounded during removal, sparks will occur
and could ignite explosive gases.
NOTE: The electrical system is a negative ground
system. Connect the positive (+) cables
to the positive (+) posts of both batteries.
Connect the ground (-) cables to the
negative (-) posts of both batteries.
NOTE: When replacing the batteries, dispose of the
old batteries properly in accordance with
laws and regulations.
Master Disconnect Switch
When servicing the electrical system
or welding on the grader, always turn the
master disconnect switch (Figure 5-7) to
the OFF position, disconnecting the ground
from the batteries, to prevent damage to the
grader's electrical system.
1.
Open engine access panel (Figure 3-1,1) located
on left side of grader to locate master disconnect
switch (Figure 5-5).
Maintenance
5-13
5 5
Advertisement
Table of Contents
