Overlap Dialing (Bri); En Bloc Dialing - Agilent Technologies aurora Duet User Manual

Duet
aurora Basic & Primary Rate ISDN Tester - User Guide
The last number dialed is automatically displayed.
The way you enter the CPN will depend on whether the
dialing type is set to OVERLAP or EN BLOC in the DIAL
SETUP screen. For details, see Chapter 9.
Overlap dialing
•
•
•

En Bloc dialing

•
•
•
•
10 - 8
and RIGHT arrow keys to switch between the
available options. You can choose between
PRIMARY 1-6, PRIMARY 7-12, PRIMARY 13-18,
SECONDARY 1-6, SECONDARY 7-12,
SECONDARY 13-18 and SECONDARY 19-24.
To dial the last CPN, while it is still displayed, select
DIAL.
To enter a new Called Party Number (CPN), use the
keypad to enter up to 20 digits.
With Overlap dialing, each digit you enter is sent
immediately to the exchange until the call connects.
This means that you cannot delete the digits you
enter.
To access the CPN DIRECTORY (see Chapter 9) and
dial one of the stored CPNs, select RECALL.
To dial the last CPN, while it is still displayed, select
DIAL.
To delete the last CPN and start entering a new one,
press any number on the keypad. You can use the
LEFT arrow to delete from the end of the number.
To dial a new CPN, use the keypad to enter up to
20 digits. To delete the last digit you entered, press
the LEFT arrow key.
Move the cursor to DIAL and press SELECT. With
En Bloc dialing, all the digits you enter are sent as a
group to the exchange.
428856