Table of Contents
Advertisement
Getting Started
CAPTURE REVIEW
Allows you to review or output captured trace data. See
Chapter 7 for details.
RESULTS
Displays test results. For more information, see Chapter
6.
S BUS TEST
Allows you to switch between S Bus Test ON and OFF,
by pressing the LEFT and RIGHT cursor keys.
If you choose ON, aurora
outputs a continuous
Duet
repeating pattern of consecutive pulses to the S Bus cable
check connector. This can be used to test an S Bus cable
connected between the connector and the optional S Bus
Tester. For more information, refer to the S Bus Cable
Testing User Guide. The default setting is OFF: if you
choose this, aurora
does not output any S Bus pulses.
Duet
U INTERFACE
When the U-interface is selected, you can choose this
option to perform a manual activation of the U-interface.
For more information, see Chapter 5.
MONITOR
Accesses monitor functions. These are described in
Chapter 7.
T1 TEST
Accesses menus and screens that allow you to set up and
perform testing of the physical layer (also known as
Layer 1). For details, see Chapter 6.
SETUP
Accesses menus allowing you to set up both general
parameters (see Chapter 5) and protocol-specific
parameters (see Chapter 8).
Issue 2 - 05/00
4 - 7
Hide quick links:
Advertisement
Chapters
Table of Contents
