Agilent Technologies aurora Duet User Manual page 41

Issue 2 - 05/00
Comms Port—This is a 15-pin connector that can be
configured from the menu system to act as either a high
speed parallel interface or an RS232 serial port. It is
used for connection to a PC, terminal or printer for
remote reporting and control. Separate cables are
provided for connecting to serial or parallel devices.
Primary Rate Tx/MON/Rx connector (PRI Port 1)—This
RJ-45 connector, with a transmitter and receiver, is used
for simulation/monitor functions on the T1 interface.
Primary Rate Tx/MON/Rx connectors (x 2)—These
Bantam connectors, each with a transmitter and receiver,
are used for simulation/monitoring on the T1 interface.
This means that, for example, you can monitor, capture
and decode D and B channel traffic on two receive ports
at the same time from a single T1 line, or use both T1
ports to test multiple T1 installations using NFAS.
'S' Bus cable check connector—This RJ-45 socket is used
for S Bus cable checking in 'S' tests.
'S/T' Interface connector—This RJ-45 socket is used for
connection to the ISDN 'S' and 'T' reference points for
simulation/monitor functions. An RJ-45 'T' piece may be
used for monitoring on an S Bus. See the diagrams
overleaf.
'U' Interface connector—These RJ-45 sockets are used
for connection to the ISDN 'U' reference point for
simulation/monitor functions. Refer to the diagrams
below.
A Look at aurora Duet
3 - 9