Choosing The Type Of Monitor Trace Output; Types Of Output Available - Agilent Technologies aurora Duet User Manual

Duet
aurora Basic & Primary Rate ISDN Tester - User Guide

Choosing the type of Monitor trace output

To define the tracer setup, use the arrow keys to switch
between the available options. The types of output that are
available to you will depend on whether aurora
MONITOR or SIMULATE mode.
TRACER
TRACER

Types of output available

Depending on whether your aurora
SIMULATE mode, you can select from the following types
of output:
TO MEMORY
EXPERT TO COMMS
5 - 16
You can choose between TO
MEMORY, EXPERT TO COMMS,
DECODE TO COMMS, SIMPLE TO
COMMS, TEST TO COMMS,
RESULTS TO COMMS and OFF.
You can choose TO MEMORY or
EXPERT TO COMMS.
is in MONITOR or
Duet
Layer 2 and 3 data is stored in
the memory for use with the
TRACE CAPTURE REVIEW menu.
For more information, see
Chapter 7.
If you choose TO MEMORY, a
MODE setting appears, which
you can set to FILL or WRAP. In
FILL mode data is stored until the
memory is full. In WRAP mode
data is stored continuously, and
when the memory is full the
oldest data is replaced by new
data.
This output is used for
communication with other
products, currently aurora
is in
Duet
.
Expert
428856