Setting Up An Outgoing Call - Agilent Technologies aurora Duet User Manual

Duet
aurora Basic & Primary Rate ISDN Tester - User Guide
F5
F6

Setting up an outgoing call

The way in which you set up an outgoing call will depend
upon:
•
•
When you select a bearer capability or service from the
CALL SETUP menu:
•
•
Note:
You can only make DATA Nx64K calls when using the
Nortel or NI protocols, in PRI mode.
10 - 4
Allows you to select a Service Profile ID
SPID
(SPID) to use for the call. By pressing
F5 you can switch between SP1 and
SP2. The current selection is displayed
at the top of the screen.
For information on how to set up
SPIDs, see Chapter 9.
Returns you to the MAIN menu.
EXIT
the bearer capability or service you are using
the way in which dialing is set up—i.e. Overlap or
En Bloc
For all types of call except DATA Nx64K, aurora
displays the DIAL screen.
For DATA N*64K calls, which are used for BERT
on multiple channels, before the DIAL screen
aurora displays the BERT CHANNELS screen, for
Duet
you to set up the channels on which BERT is to be
performed. When you have set up the channels,
aurora proceeds to the DIAL screen.
Duet
Duet
428856