Setting Up aurora
aurora
specific to particular protocols and others that are
independent of protocol.
This chapter describes the protocol-independent setup
functions that are available from the MAIN menu for
SIMULATE and MONITOR modes. The protocol-
specific setup functions are described in Chapters 8
and 9.
Chapter Summary
The chapter begins with a description of the Hot Keys
and how to use them, then goes on to describe the
following menus, screens and options:
U INTERFACE
MAIN SETUP
REAL TIME FILTER SETUP This screen is accessed from
Issue 2 - 05/00
allows you to set up some parameters that are
Duet
This screen is accessed from
the MAIN menu. It allows you
to perform a manual
activation of the U interface,
when the U interface is
selected.
This menu is accessed from
the MAIN menu. From here
you can access screens and
sub-menus that allow you to
set up a variety of general and
BERT (Bit Error Rate Test)
parameters.
the MAIN SETUP menu. It
allows you to specify a set of
filters to control the type of
data that is captured during
the monitor procedure.
Duet
Setting Up aurora
Duet
5 - 1
5