Biotek Synergy HT Operator's Manual page 31

Chapter 2
Installation
This chapter includes instructions for unpacking and setting up
the Synergy HT and, if applicable, the external dispense module.
Instructions are also included for repackaging the reader and
dispense module for shipment.
Product Registration ............................................................... 8
1: Unpack and Inspect the Reader ............................................ 8
2: Remove the Shipping Panel ............................................... 10
3: Remove the Microplate Carrier Shipping Screw ..................... 12
4: Install the Fluorescence Lamp Assembly .............................. 13
5: Select an Appropriate Location ........................................... 14
6: Connect the Power Supply ................................................. 14
7: Unpack and Inspect the Dispense Module ............................ 15
8: Install the Dispense Module ............................................... 19
9: Connect the Host Computer ............................................... 23
10: Install Gen5 Software ...................................................... 23
11: Turn on the Reader ......................................................... 23
12: Establish Communication ................................................. 24
13: Run a System Test ......................................................... 25
14: Test the Injector System ................................................. 26
Operational/Performance Qualification ..................................... 28
Repackaging and Shipping Instructions ................................... 28