xiv
Preface
|
Precautions
The following precautions are provided to help avoid damage to the instrument:
Caution: Service.
personnel. Only qualified technical personnel should perform troubleshooting and
service procedures on internal components.
Caution: Spare Parts.
The use of unapproved spare parts and accessories may result in a loss of warranty
and potentially impair instrument performance or cause damage to the instrument.
Caution: Environmental Conditions.
temperature extremes. For proper operation, ambient temperatures should remain
within the range listed in the
affected if temperatures fluctuate above or below this range. Storage temperature
limits are broader.
Caution: Sodium Hypochlorite.
recommended diluted sodium hypochlorite solution (bleach) for more than 20
minutes. Prolonged contact may damage the instrument surfaces. Be certain to rinse
and thoroughly wipe all surfaces.
Caution: Power Supply.
Operate this power supply within the range of line voltages listed on it.
Caution: Disposal.
lead solder. Dispose of the instrument according to Directive 2002/96/EC, "on waste
electrical and electronic equipment (WEEE)," or local ordinances.
Caution: Warranty.
the warranty
Caution: Shipping Hardware.
operating the instrument and reinstalled before repackaging the instrument for
shipment.
Caution: Electromagnetic Environment.
responsibility to ensure that a compatible electromagnetic environment for this
instrument is provided and maintained in order that the device will perform as
intended.
Caution: Electromagnetic Compatibility.
proximity to sources of strong electromagnetic radiation (e.g., unshielded intentional
RF sources), because these may interfere with the proper operation.
The instrument should be serviced by BioTek authorized service
Only approved spare parts should be used for maintenance.
Specifications
Do not expose any part of the instrument to the
Only use the power supply shipped with the instrument.
This instrument contains printed circuit boards and wiring with
Failure to follow preventive maintenance protocols may
.
All shipping hardware must be removed before
Do not expose the instrument to
section. Performance may be adversely
Per IEC 61326-2-6 it is the user's
Do not use this device in close
BioTek Instruments, Inc.
void
Need help?
Do you have a question about the Synergy HT and is the answer not in the manual?