Biotek Synergy HT Operator's Manual page 142

116
Chapter 5: Preventive Maintenance
|
Turn the top probe screw counterclockwise to lower the probe hanger all
5.
the way to the bottom. (Rotate the screw, not the ring around it.)
6. Gently lift the left side of the incubator housing and carefully slide it out.
Note:
When replacing the
incubator housing,
the two "forks" on
its right side should
wrap around the
holding screws.
The forks should
not slide under the
fixed foam housing.
Rotate
counterclockwise
BioTek Instruments, Inc.