Biotek Synergy HT Operator's Manual page 17

Warning! Service.
procedures on internal components.
Warning! Accessories.
specifications shall be used with the instrument.
Warning!
when lifting and carrying the instrument.
Warning! Lubricants.
track. Lubricant on the carrier mechanism or components in the carrier compartment
will attract dust and other particles, which may obstruct the carrier path and cause
the instrument to produce an error.
Warning! Liquids.
internal components creates a potential for shock hazard or instrument damage. If a
spill occurs while a program is running, abort the program and turn the instrument
off. Wipe up all spills immediately. Do not operate the instrument if internal
components have been exposed to fluid.
Warning! Unspecified Use.
guidelines and safeguards specified in this manual could result in a hazardous
condition.
Warning! Software Quality Control.
manufacturer's assay package insert when modifying software parameters and
establishing reading, washing, or dispensing methods.
control checks could result in erroneous test data
Warning! Reader Data Reduction Protocol.
absorbance data. All information exported via computer control must be thoroughly
analyzed by the operator.
Warning! Potential Biohazards.
biohazard. Adequate safety precautions should be taken as outlined in the assay's
package insert. This hazard is noted by the symbol shown here. Always wear safety
glasses and appropriate protective equipment, such as chemically resistant rubber
gloves and apron.
Warning! Hot Surface.
on. Turn off the reader and allow the lamp to cool down before attempting
replacement.
Warning! Pinch Hazard.
pinch hazards when the instrument is operating. The module is marked with
one of the symbols shown here. Keep hands/fingers clear of these areas
when the instrument is operating.
Synergy HT Operator's Manual
Only qualified technical personnel should perform service
Only accessories that meet the manufacturer's
The instrument weighs approximately 38 pounds (17 kg). Use two people
Do not apply lubricants to the microplate carrier or carrier
Avoid spilling liquids on the instrument; fluid seepage into
Failure to operate this equipment according to the
The lamp assembly is hot when the instrument is turned
The operator must follow the
Failure to conduct quality
.
No limits are applied to the raw
Some assays or specimens may pose a
Some areas of the dispense module can present
xiii
Hazards
|