Cleaning The Reader's Internal Surface - Biotek Synergy HT Operator's Manual

Multi-mode microplate reader
Hide thumbs Also See for Synergy HT:
Table of Contents

Advertisement

120
Chapter 5: Preventive Maintenance
|

Cleaning the Reader's Internal Surface

1.
If you have not already done so, unplug the instrument and remove its shroud
(see page 106 for instructions). Follow the instructions under
Optical Probes
ground wire, lower the top optic probe hanger, and remove the incubator
housing (steps 1 through 6).
2.
Manually slide the microplate carrier to the left to engage the support pin, and
then away from the center surface.
3.
Moisten (
and mild detergent. Wipe all sides of the plate carrier. Wipe the instrument's
horizontal surface.
to (at a minimum) disconnect the incubator wires, detach the
do not soak
) a clean cotton cloth with alcohol, water, or with water
Microplate carrier,
fully extended
Cleaning the
BioTek Instruments, Inc.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Synergy HT and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF