Operational/Performance Qualification; Repackaging And Shipping Instructions - Biotek Synergy HT Operator's Manual

28
Chapter 2: Installation
|

Operational/Performance Qualification

Your Synergy HT Multi-Detection Microplate Reader was fully tested at BioTek prior
to shipment and should operate properly following the successful completion of the
installation and setup procedures described throughout this chapter.
If you suspect that problems occurred during shipment, if you received the reader back
from BioTek following service or repair, and/or if regulatory requirements dictate that
Operational/Performance Qualification is necessary, turn to
Qualification now to learn about BioTek's recommended OQ/PQ procedures for the
Synergy HT.
An Installation-Operational-Performance (IQ/OQ/PQ) package for the
Synergy HT is available for purchase (PN 7090521). Contact your local
BioTek dealer for more information.

Repackaging and Shipping Instructions

Warning!
potentially hazardous material, decontaminate it to minimize the risk
to all who come in contact with the reader during shipping, handling
and servicing. Decontamination prior to shipping is required by the
U.S. Department of Transportation regulations. See
decontamination instructions.
Caution!
from the carrier before shipment. Spilled fluids can contaminate the
optics and damage the instrument.
If the reader and/or dispense module has been exposed to
Remove the microplate and tip prime trough (if equipped)
Chapter 4, Instrument
Appendix A for
BioTek Instruments, Inc.