Introduction; Security Locks; Door Lock - Qualstar RLS-4470 Technical & Service Manual

Tape library; rls-4000 series; rls-5000 series; rls-6000 series; rls-8000 series;
Table of Contents

Advertisement

The menus in this chapter reflect revision 0.122 of the Executive PCBA EPROM software.
If the user has an earlier revision of the software, some items may not appear in the
menus. Also, not all menu items appear all the time: Some menu items are model-
dependent.

5.1 Introduction

The
\Private
leged, password-protected menu. This means that a password must be set to gain ac-
cess to the items in the
cleared before the RLS is shipped from the factory, because the menu is intended only
for use by field service personnel.
Passwords are used together with security locks to protect the RLS' configuration
against unauthorized or unintentional changes, and unauthorized manual operations.
Therefore, the
the
\Private

5.2 Security Locks

There are four types of security locks:
. The
Door
Configuration
fault value is
el/Door.
Refer to the RLS-8000 Tape Library Operation and Installation Manual (Qualstar
document number 501500) for a complete discussion of RLS security locks.
All items in the \Configuration\Security menu are locked by the Door lock.

5.2.1 Door Lock

When the cabinet's door is closed, the
figuration\Security
501510 Rev. S
menu, the root menu for the protected service menus, is also a privi-
\Private
security lock must be disabled before a password can be set in
Master
menu.
\Configuration\Security
,
, and
Inventory
). The
lock is controlled by opening or closing the Front Pan-
OFF
Door
C•••••••••••Security
Configuration:
Inventory:
Master:
menu cannot be changed.
The Private Menu
NOTE
menu. The password to the
,
Configuration
Inventory
menu (shown below) is used to set the
security locks to
Master
ON
ON
ON
NOTE
lock is
, and the items in the
Door
ON
menu is
Private
,
and
Master
or
(the de-
ON
OFF
Con-
5-3

Advertisement

Table of Contents
loading

Table of Contents