Figure 7-8 Carousel Mounting Screws Located on the Bottom of the RLS
7.8.2 Carousel Replacement
This procedure assumes the carousel was removed in Section 7.8.1.
1.
Place the carousel assembly into the chassis and align its threaded mounting
holes with the holes in the bottom of the chassis.
2.
If the RLS is not rack-mounted, carefully turn it upright.
3.
Using a No. 2 Phillips screwdriver, replace the four Carousel mounting flat-head
screws that were removed in Section 7.8.1. See Figure 7-8.
4.
Tuck the ribbon cable under the plastic retainer clips and reconnect it to the
DRVBAY connector on the 8mm Carousel PCBA. See Figure 7-7.
5.
Proceed to Section 7.24 to calibrate the RLS.
501510 Rev. S
Carousel Mounting Screws (4)
Field–Replaceable Units (FRUs)
7-17