Table of Contents
Advertisement
Rear of Library
Figure 9-6 Access Panel on Rear of the Library and Storage Array Removed from Library
9.
If the RLS is not rack-mounted, carefully turn it on its left side (as seen from the
front) so that the Storage Array mounting screws located on the bottom of the li-
brary can be accessed.
10.
There are five Storage Array mounting screws located on the bottom of the chas-
sis. Using a No. 2 Phillips screwdriver, remove the screws as shown in Figure
9-5. If the RLS is on its side, hold the Storage Array Assembly in place with one
hand while removing the final screw.
11.
Set the RLS chassis upright. Grasp the front and the rear of the Storage Array
Assembly and gently lift it up and then out through the rear of the chassis. See
Figure 9-6.
9.2.5 Style B Chassis Storage Array Expansion Kit Installation
This procedure assumes that the 4445 Storage Array was removed in Section 9.2.4.
1.
If the RLS is not rack-mounted, carefully turn it on its left side (as seen from the
front) so that the Storage Array mounting screws located on the bottom of the li-
brary can be accessed.
501510 Rev. S
RLS Expansions
Storage Array removed
from the Library.
Access Panel
9-9
Advertisement
Table of Contents
