Carriage Assembly - Qualstar RLS-4470 Technical & Service Manual

2. Reinstall the four pan-head screws removed in Section 7.6.1 using a No. 2 Phil-
lips screwdriver.

7.7 Carriage Assembly

RLS-4124/4221
RLS-4445/4470
RLS-5116
RLS-5244
RLS-6227
RLS-8116/8216H/8236/8236D
RLS-8216C/8216CD/8236C/8236CD
RLS-8202/8204/8204D/8244/8244D/8404/
8404D/8444/8444D
Please contact Technical Support for additional information about Carriage
Assemblies with the Barcode Reader Assemblies installed.
Before replacing the Carriage Assembly, open the library's Top Cover and read the RLS
Carriage Assembly Label located on the top of the Carriage Assembly to determine
which model of Carriage Assembly is installed in the library. See Figure 7-4. The label will
read 510180-xx-x. If the part number does not match those listed above, please contact
Qualstar Technical Support to obtain the correct replacement Carriage Assembly.
The Carriage Assembly contains the Handler that moves laterally and carries the Gripper
Assembly and the optional Barcode Reader Assembly. The Gripper Assembly grasps the
tape cartridges and moves fore and aft to insert or remove tape cartridges. The Barcode
Reader Assembly is an option on RLS models and may be added by replacing the existing
Carriage Assembly with one containing a Barcode Reader Assembly.
Tools Required: No. 2 Phillips Screwdriver
7-12
NOTE
Field–Replaceable Units (FRUs)
(8mm) P/N 510180-01-1
(8mm) P/N 510180-14-4
(SAIT) P/N 510180-12-8
(SAIT) P/N 510180-15-1
(SDLT) P/N 510180-15-1
(LTO) P/N 510180-12-8
(LTO) P/N 510180-02-9
(LTO) P/N 510180-15-1
501510 Rev. S