Table of Contents
Advertisement
Drive Platform
Figure 9-2 Detailed view of the Ribbon Cable attached to the Storage Array Assembly
5.
On the Interconnect PCBA, unplug the three ribbon cables. Refer to Figure 9-3.
6.
Use diagonal cutters to cut the cable tie nearest the Executive PCBA that se-
cures the round power cable going to the Executive PCBA.
7.
Remove the Sensor Master Assembly by removing the two No. 1 Phillips screws
on the right side and the two 5/64ths hex-head screws on the left side. Refer to
Figure 7-37. Lift the assembly straight up and place in a safe location.
SENSOR Connector
Figure 9-3 Top Connectors on the Interconnect PCBA
9-4
Ribbon Cable Connector
EXEC Connector
RLS Expansions
Storage Array
Ribbon Cable
DRVBAY
Connector
501510 Rev. S
Advertisement
Table of Contents
