The Private\Clear Access Command; The Open Viop Window Command; The Reboot Command; The Reset Scsi Bus Command - Qualstar RLS-4470 Technical & Service Manual

5.4.2 The Private\CLEAR ACCESS command

This command is used to clear the Access value (the active password) and defeat Pri-
vate menu access, as explained in Section 5.3.3.

5.4.3 The OPEN VIOP WINDOW command

This command moves the Handler to unlatch the VIOP window. The window must be
manually closed before the Handler can be again moved.

5.4.4 The REBOOT command

This command resets the Executive microprocessor. The RLS behaves as though pow-
er were just applied.

5.4.5 The RESET SCSI BUS command

This command forces a BUS RESET command on the SCSI bus. It may be used with
caution to solve system development problems. However, using this command could
prove quite disruptive on a live system.
Executing a RESET SCSI BUS command could adversely affect another device
or host system that is connected to the same SCSI bus. Use this command
with great caution!
To Reset the SCSI Bus:
1. Press the MENU key to open the
2. Use the
key to open the
3. Use the
4. Press the ENTER key to execute the
This command is locked by both the Master Security Lock and the Inventory Lock.
5-12
CAUTION
Top Menu
(DOWN) key to move the pointer to
menu.
Private
(UP) or (DOWN) key to move the pointer to
The Private Menu
.
, then press the ENTER
Private
RESET SCSI BUS
command.
RESET SCSI BUS
NOTE
.
501510 Rev. S