Table of Contents
Advertisement
>scanscsi *,*,*
Id,Lun,Host
0,
1,
2,
In this example, the SCSI bus scan found three devices. The first device is a
Qualstar RLS-4222, followed by two Sony Tape Drives.
Upload.exe will not work if the Id is greater than 15, or the Lun is greater than 7 when
updating the firmware in a fibre channel environment.
5.
The
upload
"DOS box". The program's command syntax is as follows:
Upload Id,[Lun[,Host]] f:<filename>
Command Parameters:
Id,Lun,Host - RLS Library SCSI address. This address can be found using the
scanscsi
Filename - Filename of the new firmware update. This file is provided by
Qualstar Technical Support.
Upload program example:
6.
Update the RLS Library with firmware file 700118.000.00042. The
program was used to locate the RLS Library is on SCSI Address : Id 0, Lun 0,
and Host 1. Note that the firmware filename may contain a sub revision letter as
shown in this example.
Upload 0,0,1 f:
The program will display the upload transfers:
700118 0.42
### Packets
7.
Do not turn off RLS power while the update is on progress. The last packet is
number 512.
501510 Rev. S
Device Type
0,
1
Medium-changer
0,
1
Sequential-access
0,
1
Sequential-access
console program is executed from a Windows command prompt or
utility program. The default Id, Lun and Host is 0.
700118.000.00042
Firmware Updating
Vendor
Product
QUALSTAR
RLS-4222
SONY
SDX-700C
SONY
SDX-700C
NOTE
Revision
042A
0102
0102
scanscsi
8-3
Advertisement
Table of Contents
