7.3 Required Tools and Materials
Table 7-3 is a complete list of the tools that would be required to replace every RLS
FRU. See individual FRU sections of this chapter for the tool needed to replace just
that FRU.
No. 1 Phillips Screwdriver
No. 2 Phillips Screwdriver
5/64-inch Allen (Hex) Driver/Wrench
1/4-inch Nutdriver or Open-Ended Wrench
Diagonal Cutters
Long Nose Pliers
Small Mirror (optional)
Flashlight (optional)
Table 7-3 Required Tools
The materials listed in Table 7-4 are required when replacing the indicated FRUs.
Qualstar
Manu-
P/N
facturer
669-1001-9
Tyton
Dennison
Dennison
Panduit
730-0017-6
Loctite 242
Threadlocker
Table 7-4 Replacement Materials
501510 Rev. S
Required Tools
Mfgr's
Description
P/N
T18R0
3-inch Cable Tie
08-433
08-404
PLT1M-M30
24077
Thread Locking
Adhesive
Field–Replaceable Units (FRUs)
Where Used
Power Cable between Drive Bay PCBA
and Executive PCBA – 2 places.
FRUs: 510172, 510183
Front Panel/Door (Bezel) Linkage
Screws FRU: 510179
7-7