Table of Contents
Advertisement
1.
Open the front panel/door as described in Section 7.4.
2.
Insert the drive filler into the empty drive bay making sure that the tab is in-
serted into the drive slot. See Figure 7-19 for a view of the drive slot location.
3.
Tilt the drive filler upwards and back towards the rear of the library until it is
vertical and fits securely in the drive bay.
4.
To remove a drive filler gently pull it backwards and downward until it is free
from the drive bay.
7.12 Serial Control Panel PCBA
P/N 501507-01-6
The Carriage Assembly must be removed from the RLS before the Serial Control
Panel PCBA can be replaced. No calibration is required after replacing the Serial
Control Panel PCBA.
Tools Required:
•
No. 1 Phillips Screwdriver
•
No. 2 Phillips Screwdriver
Figure 7-22 Serial Control Panel PCBA
7-38
EXIT
ENTER
MENU
READY
FAULT
BUSY
Field–Replaceable Units (FRUs)
Chassis
6 Mounting Screws
501510 Rev. S
Advertisement
Table of Contents
