Introduction; Scope; Supplemental Documentation - Qualstar RLS-8350 Product Specification

1.

1.1 Scope

This product specification describes the Qualstar RLS-8350 tape library, subsequently
referred to in this specification as the RLS or library. It also provides detailed
specifications of the product and is intended for use by individuals evaluating,
purchasing and/or integrating the RLS library products.

1.2 Supplemental Documentation

For information about the data interface, or other information outside the scope of
this manual, please refer to the appropriate documents listed below. The following
Qualstar and ANSI documents supplement this specification:
Subject
Installation & Operation
Service
Approved Data Cartridges
Barcode Label Specifications
SCSI Command Information
SCSI-1
SCSI-2
SCSI Parallel Interface-2 Specification (SPI-2)
SCSI Architecture Model-2 (SAM-2)
SCSI-3 Primary Commands (SPC)
SCSI-3 Primary Commands - 2 (SPC-2)
SCSI-3 Primary Commands - 3 (SPC-3)
SCSI-3 Media Changer Commands (SMC)
Automation/Drive Interface - Transport Protocol (ADI)
Automation/Drive Interface - Commands (ADI)
Serial Attached SCSI - 1.1 (SAS-1.1)
Table 1-1 Applicable Documents
511002 Rev 07-01-19
Document
RLS-8350/85XXX Series
Installation and Operation Manual
RLS-8350/85XXX Series
Technical Service Manual
Product Information Note
Product Information Note
RLS SCSI-2 Interface Manual
ANSI X3.131-1986
ANSI X3.131-1994
ANSI X3.302-1998
ANSI INCITS 366-2003
ANSI X3.301-1997
ANSI INCITS 351-2001
ANSI INCITS 408-2005
ANSI INCITS 314-1998 [R2003]
ANSI INCITS 406-2005
ANSI INCITS 403-2005
ANSI INCITS 417-2006

Introduction

Introduction
Qualstar
Document
Number
511000
511010
PIN-038
PIN-040
501551
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
1-1