Table of Contents
Advertisement
Cartridge location designators always contain one letter as follows:
F
H
MA-MZ
IA-IZ
T
Refer to Chapter 6 in the RLS-8000 Tape Library Installation and Operation Manual
(Qualstar document number 501500) for the ranges of location values and their phys-
ical locations.
To select a different designator, place the cursor on the letter and use the
the
(DOWN) key to select a different letter. To further select a location that has dig-
its, place the cursor over a digit. When magazine location digits are incremented or
decremented, the value rolls over to the next (or previous) magazine. Examples:
MA to MB or MA1 to MC5
3.6 The Menu Hierarchy
The hierarchical menu system is divided into three menus: Configuration, Mainte-
nance and Operation. Each of these menus contains several sub-menus. Some of the
sub-menus may also contain more sub-menus beneath them.
The Top Menu is the highest level in the menu hierarchy. Press the MENU key to go
to the top level at any time and from any point within the menu system. When the
Top Menu is displayed, press the EXIT key to exit the menu mode. Figure 3-5 shows
the available menu items in the Top Menu. The line items in menus and sub-menus
are organized in alphabetical order.
Line 1
Line 2
Line 3
Line 4
Figure 3-5 Top Menu
The Configuration menu contains items that may need to be changed when the RLS
is installed. Once the configuration parameters have been correctly set for a given in-
stallation, they are not changed unless something in the system's configuration is
changed. The functions available under the Configuration menu are fully explained in
the RLS-8000 Tape Library Installation and Operation Manual (Qualstar document
number 501500).
501510 Rev. S
Fixed Slots (RLS-4124 & 4221 only)
Handler
Magazine A through Magazine Z
VIOP Magazine A through VIOP Magazine Z
Tape Drive
T
The Operator Interface
(UP) or
3-13
Advertisement
Table of Contents
