Table of Contents
Advertisement
5.
Using a No. 2 Phillips screwdriver and a 1/4-inch hex nut driver or wrench if
needed, replace the two pan-head screws and nuts that were removed earlier
from the right side of the chassis. See Figure 7-27.
6.
Using a No. 2 Phillips screwdriver and a 1/4-inch hex nut driver or wrench if needed,
replace the three pan-head screws and nuts that were removed earlier from the top of
the Drive Bay PCBA Assembly mounting bracket. See Figure 7-26.
7.
If the RLS is not rack-mounted, carefully turn it on its left side (as seen from the
front) so that the Drive Bay Assembly mounting holes located on the bottom of
the library can be accessed.
8.
Using a No. 1 Phillips screwdriver, replace the seven or eight (model specific)
Drive Bay Assembly mounting flat-head screws that were removed earlier from
the bottom of the library. Note that Carousel models use seven screws to secure
the Drive Bay Assembly and Storage Array models use eight. See Figure 7-28.
9.
If the RLS is not rack-mounted, carefully turn it back to its upright position.
10.
Move the Top cover into position so that its Support Arm bracket fits over the
two threaded posts in the top of the Drive Bay Assembly. See Figure 7-25.
11.
Using a 1/4-inch hex nut driver or wrench, replace the two nuts that secure the
Top Cover Support Arm to the Drive Bay Assembly.
12.
Reconnect the cable to the POWER1 connector and the plug without a cable (if
present) to the POWER2 connector on the Drive Bay PCBA Assembly. See Fig-
ure 7-26.
13.
Install a cable tie to hold the power cable to the bracket on the top of the Drive
Bay PCBA Assembly. See Figure 7-25.
14.
Reconnect the ribbon cable to the INTER connector on the Drive Bay PCBA As-
sembly. See Figure 7-26.
15.
Slide the ribbon cable under the hold down clamp on the drive Bay Assembly.
See Figure 7-25.
16.
Remove the protective inserts (and any tape holding them in place) from both
sides (front & rear) of all the Channel connectors on the Drive Bay PCBA As-
sembly. Install these on the PCBA that was just removed.
17.
Follow the instructions in Section 7.16 to reinstall the X-Clear Emitter PCBA.
18.
Follow the instructions in Section 7.17 to reinstall the Sensor Master Assembly.
19.
Follow the instructions in Section 7.19 to reinstall all of the DFA Duplex Cables
in RLS-8236D and 8244D libraries.
20.
Follow the instructions in Section 7.18 to reinstall all of the SCSI Drive Inter-
face Adapters (DIAs) in all other RLS models.
21.
Follow the instructions in Section 7.21 to reinstall the Power Supply Module(s).
7-50
Field–Replaceable Units (FRUs)
501510 Rev. S
Advertisement
Table of Contents
