Table of Contents
Advertisement
Front of RLS
Figure 9-5 Storage Array Mounting Screws located on the Bottom of the RLS
9.2.3 Style A Chassis Storage Array Expansion Kit Installation
This procedure assumes that the 4445 Storage Array was removed in Section 9.2.2.
1.
If the RLS is not rack-mounted, carefully turn it on its left side (as seen from the
front) so that the Storage Array mounting screws located on the bottom of the li-
brary can be accessed.
2.
While grasping the front and rear of the Storage Array, guide the rear of the ar-
ray into the chassis. Orient the array such that the connector is facing the drive
bay or inside of the chassis.
3.
Maneuver the rear of the Storage Array into the left rear corner of the chassis
and then align its threaded mounting holes with the holes in the bottom of the
chassis.
4.
Using a No. 2 Phillips screwdriver, install three of the five mounting flat-head
screws that were removed earlier to secure the 4470 Storage Array as shown in
Figure 9-5.
5.
Inspect the new Sensor Slave Assembly that came with the expansion kit to be
sure the LED at its edge is perpendicular to the plane of the board. If it is not
perpendicular, the Sensor Slave Assembly should be replaced.
9-6
Storage Array Motor Access Hole
*
*
Storage Array Mounting Screws
(5) for RLS-4445
(3) for RLS-4470 shown with the *
RLS Expansions
Rear of RLS
*
501510 Rev. S
Advertisement
Table of Contents
