5.
Disconnect the ribbon cable from the DRVBAY connector on the 8mm Carousel
PCBA. See Figure 7-7. Slip the ribbon cable out from under the two plastic re-
tainer clips.
6.
If the RLS is a tabletop model, carefully turn the RLS on its left side (as seem
from the front) so that the Carousel Assembly mounting screws located on the
bottom of the chassis can be accessed.
Carousel
Assembly
Figure 7-7 Carousel Assembly in the RLS
7.
There are four Carousel mounting-screws located on the bottom of the library.
Using a No. 2 Phillips screwdriver, remove the screws as shown in Figure 7-8. If
the library is on its side, hold the Carousel with one hand while removing the
last screw to prevent it from falling and getting damaged.
8.
If the RLS is a tabletop model, carefully turn the RLS back to its normal posi-
tion, resting on its mounting feet.
9.
Lift the Carousel Assembly out towards the rear end of the chassis.
7-16
8mm Carousel PCBA
Field–Replaceable Units (FRUs)
DRVBAY
Connector
Ribbon
Cable
501510 Rev. S